Waterproof

ROCKMAX PROOF H1

HIGHLY FLEXIBLE CEMENTITIOUS WATERPROOF

Rockmax proof H1 is a two part highly flexible cementitous slurry. High elasticity to bridge the crack and watertight the concrete structure. Easy application and simple surface preparation. Can apply on damp concrete substrate with give the speed up the construction process.

Read More

ROCKMAX PROOF H2

FLEXIBLE CEMENTITIOUS WATERPROOF

Rockmax Proof H2 is two part flexible cementitious waterproof coating. Crack bridging ability, Easy application, Easy for substrate preparation and Can apply on damp surface. Area of application include bathroom, toilet, kitchen and others wet areas.

Read More

ROCKMAX PROOF H3

POLYMER MODIFIED CEMENT WATERPROOF COATING

Rockmax Proof H3 is a one component polymer modified cement based waterproof coating. Its provide excellent bonding and waterproofing to concrete substrate. Can use on portable water tank.

Read More

ROCKMAX HSC

WATER BASED CRYSTALLIZATION WATERPROOF

Rockmax HSC is a water based, chemical reaction, concrete and cement paste penetration to form a crystal matrix gel in pores, crack, void and capillaries below concrete surface. The solutions provide permanent concrete waterproof and increase concrete durability. The crystal matrix create a protection of cement paste from salt water, high contaminants water, sewage, waste water and some chemicals. Rockmax HSC will seal dead crack and hairline crack on concrete and remain active when contact with water.

Read More

ROCKMAX CRYSTALSEAL

CRYSTALLIZATION WATERPROOF

Rockmax Crystalseal is a crystallization waterproofing system based on cementitious slurry form. It consists of a selected silica aggregates, quartz sand, chemical additive and portland cement. Rockmax Crystalseal is full fill pore and capillary in concrete surface after chemical reaction develop. Rockmax Crystalseal withstand hydrostatic water pressure and permanent waterproofing system.

Read More

ROCKMAX ROOFSEAL V1

ELASTOMERIC ACRYLIC WATERPROOF

Rockmax Roofseal V1 is one part water based acrylic liquid waterproofing membrane. The special integral micro reinforcement improve tensile strength and increase durability of coating.

Read More

ROCKMAX CERAMIC V2

ELASTOMERIC CERAMIC WATERPROOF COATING

Rockmax Roofgard is one part synthetic rubber modified bitumen emulsion cold applied liquid membrane. High performance waterproofing system with high elasticity and good adhesion to substrate.

Read More

ROCKMAX ROOFGARD

ELASTOMERIC MODIFIED BITUMEN LIQUID MEMBRANE

Rockmax Roofgard is one part synthetic rubber modified bitumen emulsion cold applied liquid membrane. High performance waterproofing system with high elasticity and good adhesion to substrate.

Read More

ROCKMAX WATERPLUG

WATERPLUG

Rockmax Waterplug is quick setting cement mortar for stop water leakage. Use to stop water passage through concrete structure, concrete joint and rock foundation.

Read More

MAXSHIELD 150W

SBS SELF ADHESIVE SHEET MEMBRANE

Maxshield 150W is a cold applied self adhesive bituminous membranes. It is manufactured and formulated from modified SBS bitumen and high performance adhesive layer. This selected materials made very easy to installation. It is supplied in rolls 1meter width x 15meter long and 1.5mm thickness.

Read More

MAXSHIELD 300S

APP TORCH ON WATERPROOF ING SHEET MEMBRANE

Maxshield 300S is an atatic polypropylene plastomeric (APP) modified bitumen waterproof sheet membrane. It is formulated from high grade modified bitumen with selected elastic polymer and reinforced with non woven polyester reinforcement. The membrane provides good elongation, high puncture resistance and good mechanical characteristic. The membrane is top coated by sand or polyethylene (PE) and bottom surface protected by heat sensitive film.

Read More

MAXSHIELD 400S

APP TORCH ON WATERPROOF ING SHEET MEMBRANE
4mm THICKNESS WITH SAND OR SLATE FINISHED

Rockmax Roofgard is one part synthetic rubber modified bitumen emulsion cold applied liquid membrane. High performance waterproofing system with high elasticity and good adhesion to substrate.

Read More

EPOGARD T

Tar Epoxy Coating Chemical Resistance And Waterproofing Concrete

Rockmax Epogard T is a two component epoxy coal tar waterproofing. Cured material provides high chemical resistance, good abrasion and durability to concrete structures. It can protect concrete from chemical s, dilute acids, salt waters, high chlorine concentrate, alkalis, solvents.

Read More

EPOGARD W1

Solvent Free Epoxy Coating For Drinking Water Retaining Structures

Rockmax Epogard W1 is a two component, solvent free epoxy coating or lining. The cured material provides hard, gloss, smooth and watertight to concrete surfaces with and including abrasion and chemical resistance. It is suitable with potable or drinking water tank. The cured material is non-toxic.

Read More

MESH

FIBERGLASS MESH FOR WATERPROOFING APPLICATION

Rockmax Mesh is a fiberglass mesh use in waterproofing application. The mesh increases reinforced, tensile, adhesion and puncture resistance to waterproofing system.

Read More

POLYLASTIC SA1

100% Spray Applied Polyurea For Waterproof & Protective Coating

Rockmax Polylastic SA1 is a two component, 100% solid pure elastomeric polyurea coating. The cured membrane provides excellent flexible, durable, chemical resistance and corrosion protection. This material has been designed for machine application only.

Read More

POLYGARD V3

POLYURETHANE LIQUID MEMBRANE

Rockmax Polygard V3 is a one component, seamless liquid applied polyurethane based waterproofing membrane. The cured material provides highly flexible, root penetration resistance, excellent bonding to many substrates, crack bridging ability, elasticity with and include impervious waterproofing membrane. The material can be applied by roller or spray method.

Read More