MAXSHIELD 300S

APP TORCH ON WATERPROOF ING SHEET MEMBRANE


INTRODUCTION

Maxshield 300S is an atatic polypropylene plastomeric (APP) modified bitumen waterproof sheet membrane. It is formulated from high grade modified bitumen with selected elastic polymer and reinforced with non woven polyester reinforcement. The membrane provides good elongation, high puncture resistance and good mechanical characteristic. The membrane is top coated by sand or polyethylene (PE) and bottom surface protected by heat sensitive film.

AREA OF USES

  • Basements.
  • Tunnels.
  • Retaining walls.
  • Subways.
  • Below grade structures.
  • Balconies.
  • Roof.
  • Others.
  • ADVANTAGES

  • Good flexibility.
  • Good elongation.
  • Good elastic recovery.
  • High puncture resistance.
  • Good mechanical characteristic.
  • Will not decay.
  • Prefabricated membrane under control quality.
  • Easy to torch on.
  •  

    APPLICATION AND INSTALLATION

    PREPARATION

    Concrete substrate must be at least 28 days old. Substrate must be sound, smooth, clean, dry and free from loose materials, oil, grease or any other contaminants. In case of substrate has moisture on surface use flame torch to dry up surface prior to apply primer.

    PRIMING

    Apply Maxshield Primer on prepared substrate at approximate coverage rate 5m2 per litre and allow to dry.

    APPLICATION

    Maxshield 300S should be install using gas torch. Slowly unrolled the membrane and flame torch the membrane until the bottom surface melt but do not over heat. Side overlap must be minimum 150mm. roll overlap joint must be minimum 100mm. Lap joint should be sealed by torch. All expansion joints, movement joints and all joints must be followed and allowed follow structural design. Other joints and end points must be allowed according to specifications. The membrane must be protected immediately after installation.

    Maxshield 300S must be installed by experiences, trained and approved applicators. Installation shall be strictly in accordance with manufacture method statement instruction.

    PACKAGING

    Roll size: 1meter x 10meter.
    Roll weight: approx 30kg.