ROCKMAX SUPERCOTE 1

GENERAL PURPOSE EPOXY COATING


INTRODUCTION

Rockmax Supercote 1 is two components solvent based epoxy coating use for concrete and steel protection. Design for light to medium resistance for both walls and floors. Its provide gloss, seamless and smooth finish which easily cleaned.

AREA OF USES

  • Production areas.
  • Steel structures.
  • Kitchens and canteens.
  • Warehouse and storage areas.
  • Mechanical and electrical rooms.

    • ADVANTAGES

  • Abrasion resistance.
  • Chemical resistance.
  • Seamless and smooth surface.
  • Easy to clean.

    •  

    APPLICATION AND INSTALLATION

    PREPARATION

    Concrete must be sound, clean and free from cement paste, dust, dirt and any other contaminants. Concrete must be at least 28 days and minimum compressive strength 25N/mm2 and minimum tensile strength (pull off) at 1.5 N/mm2. The concrete moisture content must less than 4%.

    PRIMING

    Apply Rockmax Supercote P prior to apply body coat. For steel structure, please contact Rockmax for further information.

    MIXING

    Mix part A and part B approximate 3 minutes until homogeneous using electric mixer (400-500 rpm).

    APPLICATION

    Apply by brush or roller on the prepared surface. Wait until dry 24 hours prior to apply second coat.

    CURING

    Protect applied areas from foot traffic at approximate 24 hours and fully cure in 7 days.

    PACKAGING

    20 kg set.