MAXSHIELD 150W

SBS SELF ADHESIVE SHEET MEMBRANE


INTRODUCTION

Maxshield 150W is a cold applied self adhesive bituminous membranes. It is manufactured and formulated from modified SBS bitumen and high performance adhesive layer. This selected materials made very easy to installation. It is supplied in rolls 1meter width x 15meter long and 1.5mm thickness.

AREA OF USES

  • Foundations.
  • Below grade structures.
  • Retaining walls.
  • Balcony.
  • Roof desks.
  • Flat roofs.
  • Planter boxes.
  • All concrete structures.

    • ADVANTAGES

  • Excellent adhesion to concrete.
  • Good flexibility.
  • Fast and easy installation.
  • Watertight.
  • Uniform thickness.
  • Resistance to acids and alkalis.
  • Nominal thickness 1.5mm.

    • APPLICATION AND INSTALLATION

    PREPARATION

    Concrete substrate must be sound, smooth, clean, dry and free from loose materials, oil, grease or any other contaminants. In case of substrate has moisture on surface use flame torch to dry up surface prior to apply primer.

    PRIMING

    Apply Maxshield Primer on prepared substrate at approximate coverage rate 5m2 per litre and allow to dry.

    APPLICATION

    Maxshield 150W should be applied from lowest point. All joints, angles and end points must be overlap at minimum 75mm. Internal and external corners should be reinforced with 300mm membrane strip. End laps should be sealed. Ensure the membrane is perfectly stick and adhere with concrete substrate and no air pockets. It is recommended to protect the membrane by protection boards immediately. Do not exposed the membrane to direct UV for long period. Maxshield 150W must be installed by experiences, trained and approved applicators.

    PACKAGING

    Roll size: 1meter x 15meter.
    Roll weight: approx 25kg.