INTRODUCTION
Rockmax Grout GP is a pre-pack non shrink, non ferrous, free flow, self-leveling cementitious grout. It designed for general conditions purpose.
AREA OF USES
ADVANTAGES
APPLICATION AND INSTALLATION
PREPARATION
Concrete substrate must be clean, free from oil, grease, mould oil, dust and loose particles. Steel plate must be clean and no rust. Ensure there is no crack on concrete surface. Saturated concrete surface with clean water at least 4-8 hours prior pour grout.
MIXING
Mixer must use low speed drill mixer (500 rpm) with and including good quality steel paddle. Make sure all tools and equipments are in good conditions and clean.
Measure 4 litre of clean water. The amount of water is effect the flow of grout and strength of grout. Temperature of water is approximate 15ºC – 25ºC degree. Powder must be added to the clean water slowly and continuous mixing for approximate 3-4 minute. Mix all material of grout in one bag per time. Do not partial mix.
APPLICATION
Maintain good hydrostatic head. Pouring should be a continuous process to ensure the flow of the grout not allowed stop. Pouring from one side only. The grout thickness should be 80mm at one layer. Separated joint and air release hole shall be prepared prior to application. We recommended to keep sample for testing the properties of grout include compressive strength. Please consult Rockmax for more information.
CURING
Keep grout surface moist to prevent rapid drying. Use plastic sheet to wrap around grouting area. Curing compound should be use to avoid shrinkage crack.
PACKAGING
25kg bag.
STORAGE
Storage in shade and dry condition free from frost, water, moisture and high temperature.