Water Repellant

 

ROCKMAX® SUPERCOTE SL
ROCKMAX LATEX
100% SOLID SELF SMOOTHING EPOXY FLOOR

 

INTRODUCTION

Rockmax Supercote SL is a two components 100% solid epoxy resin floor topping. This product provides a high gloss, smooth, seamless, hygienic, durable and hard wearing. Rockmax Supercote SL designed for application 1-3mm thickness and suitable with industrial and commercial application.

AREA OF USES


  • Medium to heavy industrial areas.
  • Maintenance areas.
  • Laboratories.
  • Production plants.
  • Clean rooms.
  • Assembly areas.
  • Warehouses.
  • Medium chemicals plants.
  • Hygienic production plants.
  • Many other industrial environmental.

  • ADVANTAGES


  • High Chemical and abrasion resistance.
  • High Mechanical resistance.
  • Withstand foot and light vehicle traffic.
  • Non dusting.
  • Durable.
  • Hygienic.
  • Full gloss finish.
  • Solvent free and non toxic.
  • Fast curing.
  • Seamless and smooth surface.
  • Easy to clean.

  •  

    APPLICATION AND INSTALLATION

    PREPARATION

    New concrete substrate
    Concrete must be sound, clean and free from cement paste, dust, dirt and any other contaminants. Concrete must be at least 28 days and minimum Compressive strength 25N/mm2 and minimum tensile strength (pull off) at 1.5 N/mm2. Moisture content in concrete must less than 4%. All floors to received Rockmax Supercote SL topping should be protected by damp proof membrane. Total enclosed shot blasting or scarifying should be employed followed by vacuuming.

    Old concrete (Uncoated concrete)
    Old concrete or uncoated concrete floors is done in much similar manner to new concrete preparation. The concrete surface must be thoroughly cleaned with a strong detergent cleaner to remove all grease, oils and etc. Holes and cracks must be repaired use epoxy injection and epoxy mortar (please consult Rockmax for more information).

    Previously coated concrete surface
    Existing coated surface must be completely removed by sand blasting until received sound surface. Clean all surface with detergent cleaner. Total enclosed shot blasting or scarifying should be employed followed by vacuuming.

    PRIMING

    Apply Rockmax Supercote P at 1 or 2 coat. Allow to dry prior to application. Please refer Rockmax Supercote P datasheet.

    MIXING

    Stir each component separately approximate ½ to 1 minute. Mix part A and part B approximate 3 minutes until homogeneous using electric mixer (400-500 rpm). Avoid whipping air into the material. It is recommended that only full units be used, that both components are thoroughly mixed. We do not recommend using partial kits and reduce material.

    APPLICATION

    This material must be applied by specialist trained applicator. Pour mixed material directly on the surface in a long puddle and spread using either trowel or rubber squeegee. Pull through material until end of joints. Pour new material on to end of joints to maintain wet edge. Check film thickness frequently. Use spike roller to remove any entrapped air. Do not spike roller after 30 minutes.

    CURING

    Protect applied areas from foot traffic at approximate 24 hours and fully cure in 7 days.

    CLEANING

    Clean all tools and equipments immediately with acetone, xylene or other solvents.

    PACKAGING

    20kg set:
    Part A: 16kg
    Part B: 4kg