ROCKMAX EI

LOW VISCOSITY EPOXY INJECTION



*Click image to enlarge

INTRODUCTION

Rockmax EI is a low viscosity, two component epoxy resin designed for good penetration to small cracks. The cured material provides high early strength and confirms to ASTM C-881, grade 1, class 1 type B&C. The main purpose is to fill voids, cracks, holes in concretes and bonding in structural concrete repairs by injection or gravity-feed method.

AREA OF USES

  • Crack injection in structural concretes.
  • Gravity feed of cracks.
  • Bonding between concrete slabs and topping mortars.
  • Seal holes or voids in concretes.
  • Grouting dowel bars.
  • As bonding agent for epoxy mortar.

    • ADVANTAGES

  • Ideal uses for structural repairs.
  • High strength.
  • Very good bonding to concretes.
  • Deep penetration to cracks.
  • Non Shrinkage.
  • Can apply in dry or damp cracks.
  • Solvent free.

    • APPLICATION AND INSTALLATION

    PREPARATION

    There are many methods for application this type of product. Different methods depend on site condition such as size of crack, vertical or horizontals, application methods etc. Please contact Rockmax for further information.

    APPLICATION

  • Identify and mark crack line.
  • Clean all dust and loose particles.
  • Fix plastic packer along side of crack line.
  • Seal the surface of crack line with epoxy paste.
  • Inject from bottom to top.
  • Work until end of crack line.
  • Re inject again to make sure all crack was full fill.
  • Remove all the packers.
  • Make good surface by grinder machine.
  • Recheck the surface.
  • Trial test must be perform.

    • PACKAGING

    3kg set part A: 2kg, part B: 1kg
    15kg set part A: 10kg, part B: 5kg

    PACKAGING

    Storage in shade and dry condition Avoid from frost, water, moisture and high temperature.